39
LAN Control Settings
Allow you to configure the wired LAN settings. Refer to page 44.
• LAN Settings:
• When selecting “DHCP on”, “Projector IP Address”, “Subnet Mask”, "Default
Gateway" and "DNS Server" will be gray out.
• When selecting "Static IP", “Projector IP Address”, “Subnet Mask”, "Default
Gateway" and "DNS Server" will be available.
• Projector IP Address: Numerical address to identify networked computers.
• The IP Address is the number that identifies this projector on the network. You
cannot have two devices with the same IP Address on the same network.
• The IP Address “0.0.0.0” is prohibited.
• Subnet Mask: A numeric value to define the number of bits used for a network
address of a divided network (or subnet) in an IP Address.
• The Subnet Mask “0.0.0.0” is prohibited.
• Default Gateway: A server (or router) to communicate across networks (subnets)
that are divided by Subnet Mask.
• DNS Server: Setup DNS server address when DHCP is disable.
• Apply: Save and execute the wired LAN settings.
To Next Page
Loading...
