50
Using the projector in standby mode
Some of the projector functions are available in standby mode (plugged in but not
turned on). To use these functions, be sure you have turned on the corresponding
menus under SOURCE > Standby Settings, and the cable connections are correctly
made. For the connection methods, see the "Connection" on page 14 chapter.
Active VGA out
Selecting On outputs a VGA signal when the COMPUTER IN 1 and COMPUTER
OUT sockets are correctly connected to devices. The projector outputs the signal
received only from COMPUTER IN 1.
Active Audio out
Selecting On outputs an audio signal when the AUDIO IN 1 socket is correctly
connected to a proper device.
LAN Control
Selecting On allows the projector to provide the network function when it is in standby
mode. See "Controlling the projector through a LAN environment" on page 44 for
details.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker.
Be sure you have made a correct connection to the projector audio input/output jacks.
See "Connection" on page 14 for more details.
Adjusting the audio mode
1. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Audio
Settings > Audio Mode menu.
2. Press / to select a preferred audio mode.
• If available, you can press Audio Mode on the remote control to select a preferred audio
mode.
Muting the sound
1. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Audio
Settings > Mute menu.
2. Press / to select On.
• If available, you can press on the remote control to toggle the projector audio between on
and off.
Adjusting the sound level
1. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Audio
Settings > Audio Volume menu.
To Next Page
Loading...
Need help?
General
