51
2. Press / to select a desired sound level.
• If available, you can press / on the remote control to adjust the projector’s sound
level.
Adjusting the Audio In 2 setting
1. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Audio
Settings > Audio In 2 menu.
2. Press / to decide the audio input source for the AUDIO IN 2/MIC port. This
will affect the connection method for different devices, and where the sound is
from.
• When Audio is selected:
• The selected input signal determines which sound will be played by the projector speaker,
and which sound will be output from the projector when AUDIO OUT is connected. For
instance, if you select a D-Sub / Comp. 1 source, the projector can play the sound received
from AUDIO IN 1.
• When Microphone is selected:
Adjusting the microphone sound level
1. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Audio
Settings > Microphone Volume menu.
2. Press / to select a desired sound level.
• This function is only available when the SYSTEM SETTING: ADVANCED > Audio Settings >
Audio In 2 menu is set to Microphone.
Turning off the Power On/Off Ring Tone
1. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Audio
Settings > Power On/Off Ring Tone menu.
2. Press / to select Off.
• The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power On/Off Ring Tone.
Device COMPUTER IN 1 COMPUTER IN 2 Video/S-Video
Audio input port AUDIO IN 1 AUDIO IN 2 AUDIO IN 2
The projector can play
the sound from...
AUDIO IN 1 AUDIO IN 2 AUDIO IN 2
Audio output port AUDIO OUT AUDIO OUT AUDIO OUT
Device COMPUTER IN 1 COMPUTER IN 2 Video/S-Video
The projector can play
the sound from...
MIC MIC MIC
Audio output port AUDIO OUT AUDIO OUT AUDIO OUT
To Next Page
Loading...
