ViewSonic Pro9510L - Rear View Connections

4
Rear view
ITEM
LABEL
DESCRIPTION
SEE PAGE
1.
HDMI 1 /MHL
Connect the HDMI/MHL cable from an HDMI/MHL device.
Note: Set the Source to HDMI 1/MHL also can be charging connected
MHL compatible smart device as long as the projector Power
On.
2.
HDMI 2
Connect the HDMI cable from an HDMI device.
3.
DVI-D
Connect the DVI CABLE to a display.
4.
RS-232
Connects RS-232 serial port cable for remote control.
5.
Computer Out
Connect an RGB cable to a display (Pass through by VGA1 only).
6.
S-VIDEO
Connect a S-VIDEO cable from a video device.
7.
Computer In 1
Connect an RGB cable from a computer or a video enabled device.
8.
BNC
Connect a BNC cable from a computer.
9.
Computer In 2
Connect an RGB cable from a computer or a video enabled device.
10.
RJ45 (LAN)
Connect a LAN cable from Ethernet.
11.
USB
Connect a USB cable for USB host.
Note: Support 5V/1.0A for each port output as long as the projector
Power On.
12.
3D-VESA
Connect 3D IR glasses receiver unit.
13.
Kensington Security Slot
Secures to permanent object with a Kensington Lock
system.
62
14.
AUDIO IN L/R
Connect the audio cables from an audio device for VIDEO or
S-VIDEO audio input.
15.
AUDIO IN
Connect an AUDIO cable from the input device.
16.
IR
Receive IR signal from remote control.
17.
12V OUT
When connected to the screen through a commercially available
cable, the screen deploys automatically on start up of the projector.
The screen retracts when the projector is powered off (see notes
below).
18.
AUDIO OUT
Connect an AUDIO cable for audio loop through.
19.
AUDIO OUT L/R
Connect an AUDIO cable for audio loop through.
20.
VIDEO
Connect the composite cable from a video device.
S-Video
Serv ice
Video RL
Audio
In DVI-DIn1 In 2
Audio
In
RL
Audi o
OutMIC
Com puter In 1
RGBHV
Com puter O ut
LAN
Com puter In 2 3D VESAUSB
RS 232-
DVI-D
HDM I2HDM I1 MHL/
IRAudioOut
In OutRemote
Wi red
12VOut
1 2 3 4 5 6 7 8 9
1
0
1
1
1
2
1
314
15
1
6
17
1
8
19
2
0
21
2
2
23
2
4