ViewSonic VB-CAM-201 - Remote Control Pairing

15
Remote Control Pairing
1. Connect the power supply to the camera and power it on.
2. Clear the paired status of the remote control:
 Press the Menu Buon and OK


3. Trigger the camera to enter the remote control pairing mode:
 Press the Reset
to blue. This indicates it has entered pairing mode.
NOTE: 

4. Start pairing:
 Using a cleared remote control, press and hold the Menu Buon, and wait
for the pairing to complete.
 
blue.
 
NOTE: The remote control has been paired with the VB-CAM-201 at the
