ViewSonic VP231wb

14. 0 Do Auto white balance.
14.1 .Set LCD Monitor to Burn In mode (Down key + 2 key +DC power on).
14.2 .Set LCD Monitor to Factory mode (1 key + +DC power on).
14.3 .Into Factory mode (Press up key).
14.4 Color temperature recover
15.0 Adjust DOS Mode
(1) Input D-SUB
(2) Input 640x480/60Hz, 5-Mosaic pattern
(3) Push “up” key into factory mode ,then select OSD “AutoBI” function.
(4) Select “S-RGB, 9300, 6500, 5400, 5000 “TO Adjust RGB gain and “save color”.
(5) Select “CopyToDA” , “CopyToDD” function
(6) Push 1 key to Exit adjust OSD
(7) Do “All mode recall” function. (Push “2 key +DC power on”)
(1) Set LCD Monitor to Burn In mode (Down key + 2 key +DC power on).
(2) Input Chross-hatch 640 x 350 / 70 Hz
(3) Do auto adjust
(4) Input Chross-hatch 640 x 400 / 70 Hz
(5) Use Hot key function “1 key +2 key” to change mode to 640 x 400/ 70 Hz.
(7) Input Chross-hatch 720 x 400/ 70 Hz
(8) Use Hot key function “1 key +2 key” to change mode to 720 x 400/ 70 Hz.
(9) Do “All mode recall” function.(Push “2 key +DC power on”)
ViewSonic Corporation Confidential
-
Do Not Copy VP231wb
32