NOTE: The Auto Pivot function uses DDC/CI to communicate with the monitor. Before applying the Auto Pivot function,
please make sure the DDC/CI setting is set to On.
To enable the DDC/CI setting:
1. Open the OSD Menu and select the Setup Menu menu. Then press the 3 key to enter the menu.
2. Press the 1 or 2 key to select DDC/CI. Then press the 3 key to enter its sub-menu.
3. Press the 1 or 2 key to select On. Then press the 3 key to confirm.
After ensuring DDC/CI is On, proceed to set OSD Pivot to Auto:
1. Open the OSD Menu and select the Setup Menu menu. Then press the 3 key to enter the menu.
2. Press the 1 or 2 key to select OSD Pivot. Then press the 3 key to enter its submenu.
3. Press the 1 or 2 key to select Auto. Then press the 3 key to confirm.
Colorbration+
To ensure long-term color accuracy, some specific models support the hardware color calibration
function. The Colorbration+ application installation file can be found at:
http://color.viewsonic.com/support/software/ <
http://color.viewsonic.com/support/software/> .
Standard monitor packing does not include the color sensor, which the Colorbration+ application
needs for the calibration process.
Compatible color sensors include:
To Next Page
Loading...
