ViewSonic VS10400 PJ402D - Disassemble Ballast Module

Disassemble Ballast Module
1. Unplug all wires on Ballast Module (Ballast Board PIN location of connectors pls refer
to Chapter 5 )
2. Unscrew four screws on Ballast Module.
3. Remove the Ballast Module.
01635-366 *2
01635-361 *2
P1643-0016
Unscrew than life up the IR board
01635-A44-N *4
P1647-9000
P1638-152
P1635-055
19
ViewSonic Corporation Confidential
-
Do Not Copy PJ402D