98
This device complies with Industry Canada licence-exempt RSS standard(s).
Operaon is subject to the following two condions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operaon of the device.
This device complies with RSS 210 of Industry Canada. This Class B device meets all
the requirements of the Canadian interference-causing equipment regulaons.
Under Industry Canada regulaons, this radio transmier may only operate using
an antenna of a type and maximum (or lesser) gain approved for the transmier by
Industry Canada. To reduce potenal radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessary for successful
Antenna Type : Dipole, Gain : 4.35 dBi (2.4 GHz)
CE Conformity for European Countries
The device complies with the EMC Direcve 2014/30/EU and Low Voltage
Direcve 2014/35/EU. and Radio Equipment Direcve 2014/53/EU.
The following informaon is only for EU-member states:
The mark shown to the right is in compliance with the Waste Electrical
and Electronic Equipment Directive 2012/19/EU (WEEE). The mark
indicates the requirement NOT to dispose of the equipment as unsorted
municipal waste, but use the return and collection systems according to
local law.