ViewSonic VX1962wm

26
5.3 DDC Key in Procedure
Note:
1. Every time after replacing the main board, you have to do the DDC key in.
2. If you find the DDC does not conform to the LCD monitor, you have to do the DDC key in.
5.3.1 Equipment Needed
- V1962wm/wmp-3
- PC (Personal computer)
- LPT cable
- 12V DC
- Firmware upgrade program
- DDC Card
- VGA Cable
5.3.2 Install software
You must install the
at the first.
Note:
After installation, you must restart the PC to take the setup to effect.
5.3.3 Connect the DDC card as follow:
Connect to the
PC LPT
Connect this port to the VSC
V1962wm/wmp-3’s VGA
12V Input