ViewSonic X100-4K - Controlling the Projector through a LAN Environment; Configuring the LAN Control Settings

73
Controlling the Projector through a LAN Environment


browser when the computer and projector are properly connected to the same
local area network.
CONTROLNAL
R
S-
2
3
2
R
J
45
R
J
4
5
L
A
N
YP
b
PrV
GA
I
N HD
MI
Conguring the LAN Control Sengs
If you are in an Automac IP environment:
1. Take a RJ45 cable and connect one end to the RJ45 Control port of the projector,
and the other end to your network.
2. Go to: Seng > Network Sengs > Wired LAN Control.
3. Select Congure IP and ensure it is set to Automac.
4. Wait for 15-20 seconds, then re-enter LAN Sengs. Now, the projector’s

displayed.
5. Make note of the IP Address displayed in the Projector IP Address row.
NOTE:
• 
administrator.
• If the RJ45 cables are not properly connected, the Projector IP Address,

the cables are properly connected and try the above steps again.
• If you need to connect to the projector in its Standby Mode, set Standby
LAN Control to On in the Network Sengs menu.