74
If you are in a Manual
1. Take a RJ45 cable and connect one end to the RJ45 Control port of the projector,
and the other end to your network.
2. Go to: Seng > Network Sengs > Wired LAN Control.
3. Highlight LAN Sengs and select Manual IP.
4.
5.
Right to enter the value.
6. To save, select Apply and press Enter.
NOTE: If the RJ45 cables are not properly connected, the Projector IP Address,
Ensure the cables are properly connected and try the above steps again.
To Next Page
Loading...
