VIGILEC mini V1N - User Manual

Questions and Answers

E
elizabethoconnellAug 10, 2025
Why does my VIGILEC mini V1N Water Pump alarm trip?
- D
  Dana MasonAug 10, 2025
  The pump alarm may trip due to several reasons: * The overcurrent adjustment (Amp. max/Amp. min) is too low or critical: Check the motor consumption and readjust the intensity. * The motor is not connected: Connect the motor. * There is an input phase failure (Vigilec mini): Check the three supply phases. * There is abnormal excessive motor consumption: Check the motor for overload. * Low motor consumption is below 0.5A: Check the pump for issues such as no water in the pump intake or a clogged pipe.
D
Dawn SantosAug 18, 2025
What to do if my VIGILEC Water Pump doesn't work and the voltage light is off?
- S
  Stacy RodriguezAug 18, 2025
  If your equipment isn't working and the voltage light is off, even when connected to a power source, consider these possible causes: * The control fuse may be burned out: Replace the corresponding fuse. * There may be excessive power voltage: Measure and check the power voltage. * There could be a wrong input connection (Vigilec Mini): Connect correctly. * There may be a phase failure (Vigilec Mini): Check the phases.
B
Brian ButlerAug 26, 2025
What to do if the level control doesn’t work correctly in VIGILEC mini V1N?
- T
  Travis Hartman DDSAug 26, 2025
  If the level control isn’t working correctly, here are a few things to check: * High and low level probes might be reversed: Place the probes in the correct position. * There could be a wrong ground connection: Check the ground connection. * Wires might be cut (Probes/Remote): Check the wires' continuity.
J
James KingSep 2, 2025
What to do if my VIGILEC mini V1N system is working but the contactor does not activate?
- V
  vjohnsonSep 2, 2025
  If the system is working but the contactor doesn't activate, it could be due to a voltage selection error (Vigilec mini). Verify the voltage selection.