Contact us at support@vikeri.tech
screws.
If you want to put the camera on a tree.
1. Pass the Installation Belt through the support on the back of the camera. If
the Belt is too long for the tree which you choose, there are 3 holes on each
side the support, you could pass the Installation Belt through several holes to
shorten the belt.
2. Put the camera on the bottom of the tree.
3. Go to the other side of the tree, pass the belt through the buckles by
following the picture.
4. Adjust the position of the camera then tightens the belt.
5. If you afraid that the camera would fall, you could also use the Fixation Kit
and the Installation Belt together to make sure that the camera is sturdily fixed
on the right position.
To Next Page
Loading...
