Contact us at support@vikeri.tech
QUICK START GUIDE
Please refer to the instructions below for a quick start of your A1
We hope you can know the mode below before trying to use A1.
Power switch mode
"OFF": Power off, A1 won't do any things.
"TEST": This mode is usually used to set up the camera and perform
some function tests (LCD screen is bright). A1 will not shoot
automatically in test mode. Instead, you can do the shoot test manually.
The icon in the top left corner of the LCD screen indicates the current
work mode and the number to the right of the icon indicates the
current camera pixel parameter. The number in the top right corner of
the screen indicates the length of recordable or number of photos that
can be taken.
This figure is the camera's estimate of the remaining capacity of the
memory card.
"ON": A1 will flash blue light and countdown 15 seconds when you
switch to this mode. It means that A1 is being prepared and will start
work soon. A1 will turn off the blue light and screen when the
countdown is over. It indicates that the camera has started working.
To Next Page
Loading...
