Viking 57085 - Operating Instructions; Using the Work Light; Jump Starting a Vehicle

Page 7For technical questions, please call 1-888-866-5797.Item 57085
SAFETYOPERATIONMAINTENANCE SETUP
Operating Instructions
Using the Work Light
1. Press and hold the LIGHT/USB Button
approximately 3 seconds to turn the
Work Light on in bright mode.
2. Press the Button repeatedly to cycle through
low, flashing, rapid flashing, and SOS modes.
3. To turn the Work Light off, press
the LIGHT/USB Button.
Jump Starting a Vehicle
Note: Read the vehicle owner’s manual pertaining
to jump starting prior to using the Jump Starter.
1. Press TEST/AIR Button to check battery
level. The Jump Starter must be fully charged.
Recharge as needed, according to Charging
the Jump Starter on page 6.
2. Turn off the vehicle ignition switch and all
accessories (lights, radio, climate control, etc.).
3. Turn Clamp Power Switch off. You may
leave the Work Light on if needed.
WARNING! TO PREVENT SERIOUS INJURY:
DO NOT TOUCH POSITIVE AND NEGATIVE
BATTERY CLAMPS TOGETHER.
4. Connect the red Positive Battery Cable to
vehicle’s positive battery terminal. Connect
the black Negative Battery Cable to a non-
moving metal part of the vehicle.
WARNING! TO PREVENT SERIOUS INJURY:
DO NOT CONNECT TO THE NEGATIVE
TERMINAL OF THE BATTERY.
Note: If the Battery Clamps are connected incorrectly,
an alarm will sound and Error Code Er1 will appear on
the Display. Review and change the connections.
If the battery’s voltage is too high, an alarm will
sound and Error Code Er2 will appear on the Display.
Disconnect the Battery Clamps, it will not
be possible to jump start with this unit.
5. When the correct connection has been made,
the “external battery voltage value” will appear on
the Display. Turn the Clamp Power Switch ON.
6. Attempt to start the vehicle. If the vehicle does not
start within 5 seconds, turn Clamp Power Switch
off and wait at least 3 minutes before trying again.
7. After the vehicle is started, turn the Clamp Power
Switch off. Remove the black Negative Battery
Cable first, and then the red Positive Battery Cable.
8. Recharge the Jump Starter.