To Next PageTo Next PageWhy is my Viking RDDFF236 Refrigerator ice maker not operating?
If the ice maker in your Viking Refrigerator isn't working, first, make sure the freezer isn't too warm. Then, check that the shut-off arm is in the “ON” position. Also, verify the water valve and water supply are functioning correctly.
Why is my Viking RDDFF236 Refrigerator running continually?
If your Viking Refrigerator runs continually, there are several potential causes. First, adjust the control setting to a medium level. Then, check the door seal to ensure proper closure, replacing it if necessary. Also, clean the condenser coil if it's dirty, and verify the condenser/evaporator fan's movement and operation. Finally, verify the operation of the control board and ensure the heat exchanger hasn't separated.
Why is my Viking RDDFF236 Refrigerator freezer too warm?
If your Viking freezer is too warm, consider the following: Adjust the control setting to medium. Check the door seal and replace if needed. Clean the condenser coil if it's dirty. Verify the condenser fan operation and ensure it's free of obstructions. Check the control board and defrost heater operation. Lastly, verify the thermistor operation.
What to do if my Viking Refrigerator unit will not operate?
If your Viking Refrigerator won't operate, check the power supply to verify the voltage. Also, reset the circuit breaker and ensure the power switch is in the “ON” position.
What causes excessive water fill volume in my Viking Refrigerator?
If there is excessive water fill volume, adjust the water fill screw at the ice maker, reduce water pressure, replace the water valve, or replace the ice maker.
What causes low water fill volume in my Viking RDDFF236 Refrigerator?
If there is low water fill volume, adjust the water fill screw at the ice maker. Also, clear any obstructions in the supply line or supply valve, and consider replacing the water valve.
What causes cubes falling back into mold during ejection in Viking Refrigerator?
If cubes are falling back into the mold during ejection, check the fill level and align the fill cup.
Why is my Viking Refrigerator too cold?
If your Viking Refrigerator is too cold, adjust the control setting to the medium position. Also, verify the proper operation of the control board and ensure proper airflow.
What causes hollow cubes in a Viking RDDFF236?
Hollow ice cubes can be caused by several factors: low water in the mold due to a thermostat short cycle (replace the ice maker thermostat), the unit or ice maker not being level (level the ice maker or unit), obstructions in the fill tube (remove obstructions), or low water pressure (replace the filter).
What to do if my Viking Refrigerator is running but has no lights?
If your Viking Refrigerator is running but the lights are not working, first, check if it's in Sabbath Mode and take it out of this mode. If not, there may be an open circuit, requiring replacement of the control board. Also, try replacing the light bulb.
General| Brand | Viking |
|---|---|
| Model | RDDFF236 |
| Category | Refrigerator |
| Type | French Door |
| Refrigerator Capacity | 15.1 cu. ft. |
| Finish | Stainless Steel |
| Color | Stainless Steel |
| Ice Maker | Yes |
| Water Dispenser | Yes |
| Energy Star Certified | Yes |
| Width | 35.75 inches |
| Depth | 29.19 inches |
Provides important safety messages and alerts for hazards.
Lists potential hazards like tip over, electrical shock, and burn hazards.
Explains how to use the appliance's control panel and its functions.
Details how to adjust refrigerator and freezer temperatures using controls.
Details test points and readings for various components connected to the control board.
Provides common problems, probable causes, and corrections for appliance issues.
