22
DOOR REMOVAL
1. Open the door approximately 15* to 20* then
slowly pull upward until the door stop (A) pops
out of the door socket. Gently close the door until
the door stops rest against one of the stop notches
(C). Slide the door up until completely free of the
hinge arms.
When the door stops pop out of the door too soon
the door will not slide off. When this happens:
a) Lower the door until the door stops
disappear into the door;
A. DOOR (Vertical adjustment screw)
B. DOOR STOP (Holds hinge in place while
removing or replacing the door)
C. DOOR HINGE SPRING (Color denotes
part number)
b) Grasp the door near the lower end;
c) Place your thumbs over the door socket
openings to prevent the door stops from
popping out;
d) Hold the door stops in the door while
sliding the door up approximately inches;
e) Release the door stops and gently close
the door until the door stops rest against
one of the stop notches.
2. To replace the door, place the hinge arms into the
door sockets. Slide the door down close to the
door stops and release the pressure from the stop
notches. Slowly lower the door down completely
allowing the door stops to retract into the door
socket.
To Next Page
Loading...
