PROBLEM CHECK POSSIBLE CAUSE REMEDY
e. Placement of 1. If white rubber “shelf 1. Properly place the glass
glass shelves bumper” do not space shelves in the unit. White
in cabinet the glass shelf out away rubber “shelf bumper”
from the molded inner- must be placed so as to
liner shelf supports on create an air space gap
the back of the cabinet between the rear edge of
interior. The cold air the glass shelf and the
from the evaporator can molded shelf supports on
be “trapped” above the the cabinet interior.
the shelf resulting in
the area above the
shelf becoming too
cold and below too
warm. (This applies to
models with glass
shelves only.)
2. Interior a. Thermostat 1. Thermostat set to too 1. Adjust thermostat, to a
too warm low (warm) of a setting. colder setting (higher
number on knob).
2. Thermostat failed, 2. Replace thermostat. Leak
cutting compressor check the sealed
off too soon. Refrigeration system.
Locate and correct the
source of the leak.
Replace the drier and
recharge to proper
amount.
2a. Replace the thermostat
with the solid state AC
control..(See appendix
page15).
b. the evaporator 1. Refrigerant leak. 1. Leak check the sealed
for the presence refrigeration system.
of a frost locate and correct the
pattern not source of the leak. Replace
present with the drier and recharge to
compressor proper amount.
operating.
F90571
8
To Next Page
Loading...
