EN
12
Roxie: 40170
3.3.2 Conguration procedure via push buttons
To proceed with the following congurations, the device must be in conguration status, as described in the previous chapter 3.3.1.
3.3.2.1 Default reset
Deletes all the contents of the outdoor station congurations (including Bluetooth association and stored access control keys or
cards) and resets to the factory default status.
1. Press push button 2 for at least 4 seconds.
2. Operation completed conrmed by a beep and a “conrm the operation” signal.
Works only within 1 minute after powering the outdoor station.
If the procedure is attempted after one minute, the red LED ashes and an “operation not permitted” beep is emitted.
Having restored the device to the factory default setting, the Bluetooth association procedure can be enabled in the following 15
minutes, as if the device had been powered up again.
3.3.2.2 Restarting the Due Fili Plus system
1. Press push button 4 for at least 4 seconds.
2. Operation completed conrmed by a beep and a “conrm the operation” signal.
3. On restarting the system, the outdoor station is also restarted.
Works only within 1 minute after powering the outdoor station.
If the procedure is attempted after one minute, the red LED ashes and an “operation not permitted” beep is emitted.
To Next Page
Loading...
Need help?
General
