Vimar ELVOX Roxie 40170 - Access to Push Button Configuration Status; Configuration Procedure Via Push Buttons; Default Reset; Restarting the Due Fili Plus System

EN
12
Roxie: 40170
3.3.2 Conguration procedure via push buttons
To proceed with the following congurations, the device must be in conguration status, as described in the previous chapter 3.3.1.
3.3.2.1 Default reset
Deletes all the contents of the outdoor station congurations (including Bluetooth association and stored access control keys or
cards) and resets to the factory default status.
1. Press push button 2 for at least 4 seconds.
2. Operation completed conrmed by a beep and a “conrm the operation” signal.
Works only within 1 minute after powering the outdoor station.
If the procedure is attempted after one minute, the red LED ashes and an “operation not permitted” beep is emitted.
Having restored the device to the factory default setting, the Bluetooth association procedure can be enabled in the following 15
minutes, as if the device had been powered up again.
3.3.2.2 Restarting the Due Fili Plus system
1. Press push button 4 for at least 4 seconds.
2. Operation completed conrmed by a beep and a “conrm the operation” signal.
3. On restarting the system, the outdoor station is also restarted.
Works only within 1 minute after powering the outdoor station.
If the procedure is attempted after one minute, the red LED ashes and an “operation not permitted” beep is emitted.