CM1 USER MANUAL
25
5.8 Camera alarm arming settings:
I / O Alarm input: When normally open, alarm input port connect with an external
alarm sensor (such as door sensor, infrared, smoke alarm detector, etc.) must be
a normally open alarm probes. When alarm occurs, the probe switch is closed;
network cameras generate alarm triggers, alarm calls according to user settings.
I / O Alarm output: When normally open, alarm output port corresponding
external alarm devices (such as alarm loudspeakers, sound and light alarm
equipment, etc.) must be a normally open type, when an event has occurred, the
user sets the Alarm I / O port output , camera alarm output switch is closed,
trigger external alarm devices.
Sensitivity: To set the sensitivity of motion detection, the greater the value the
higher the sensitivity, relatively the probability of false alarms generated will be
Adjust the
sensitivity
Apply
To Next Page
Loading...