VINCI NANO - Warnings

9
10
IMPORTANT INFORMATION BEFORE USE:
BREW
IMPORTANT: Before first use wash the interior of the Carafe(E) and
K-Cup® Holder(G) with warm soapy water. NEVER submerge Carafe(E)
or Power Base(I) in water. See full cleaning instructions on pages 16.
Never use the Vinci Nano Brewer without water in the carafe.
Operating without water can cause the temperature to exceed
the preset limit; as a safety feature, your brewer will switch off
automatically, and the Brew Button will be illuminated purple. This
is an indication of overheating due to no water. Once the brewer’s
temperature returns to its desired range, it can be used again -
indicated by a blue “Brew Button.”
This safety shut-off function will be activated within 20-60 seconds of
exceeding the temperature and should reset within 30 minutes once
the temperature has reduced.
To avoid potential malfunction, ensure the carafe contains at least 4oz
of water before powering up your brewer.
If you have removed and reattached your brewer to its power base
while it is still too hot, the Brew Button will instantly turn purple when
you begin a new brew cycle, preventing it from starting.
WARNING: Even with this safety feature, it is possible that
overheating will cause a permanent failure of the brewer. It is critical
to never activate a brew cycle without water in the carafe.
CAUTION: DO NOT add cold water to the carafe to attempt to cool
it, as this could lead to a malfunction or breakage.
IMPORTANT:
HOW TO USE YOUR NANO BREWER
IMPORTANT: Make sure that all surfaces are all clean of any unwanted minerals or coffee grounds
before using. This will ensure that the brewer will provide the best cup of cold brewed coffee.
Plug into an electrical outlet and make sure
the Power Base(I) is on a dry, flat surface. Place
the Nano Brewer onto the Power Base(I).
Securely hold the base of the Carafe(E) and
slide your finger in an upward motion on
the Lid Release(C) to unlock and open the
Control Lid(B) .
1
3
2
4
Make sure that the K-Cup® Holder(G) is
secured and “Locked” in the correct position.
Illustrations to the left shows the Unlocked
(Fig. A) and Locked (Fig. B) position.
GETTING STARTED
ADD WATER
LOCK K-CUP HOLDER
PLUG POWER
Fill the Carafe(E) with fresh, room temperature
filtered water to your desired level: The
minimum level is 4 oz for the brewer function
to work properly. The suggested maximum is
12 oz.
NUB
OPENING
UNLOCKED LOCKED
SPOUT
“BEEP”
DO NOT SUBMERGE
IN WATER
(Fig. A)
(Fig. B)