19.Make sure the wires are tted into the
plastic groove and mount the gasket. It’s
important to check that the sealing strip
provides a tight seal all the way round.
If it does not, carefully heat the strip all
the way round using a hair dryer. Then
ease the strip slightly outwards so that it
forms a tight seal against the cabinet. Be
careful not to heat the strip so much that
it melts!
21.Pull the wire through the bushing before
mounting it into the door hinge hole.
20.Dismount the door hinge bushing and
mount it on opposide side.
22.Reverse the door again and displace it
a little on the cabinet proportion to the
botton hinge.
To Next Page
Loading...
