39
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Refit
47 The LH or RH loading bar assembly is refitted as follows (Fig 6.3):
47.1 Apply white bearing grease to both washers-actuator bearing (120) and drawn cup needle
bearing (123).
47.2 Fit washer-actuator bearing (120) to side plate assembly (82) or tilt drag unit assembly (100) stub
shaft (134) with the chamfer of washer (120) towards stub shaft (134) shoulder.
47.3 Fit loading bar assembly (119) or (130) to the stub shaft with the rollers towards the rear and the
chamfered end downwards.
47.4 Fit second washer-actuator bearing (120) to stub shaft (134).
47.5 Retain the loading bar assembly on stud shaft (134) with external circlip (121).
47.6 Comply with Para 6.
Side plate assembly
Remove
48 The side plate assembly (82) is removed as follows (Fig 6.4):
48.1 Comply with Para 6.
48.2 Remove RH loading bar assembly (119) as detailed at Para 44.
48.3 Exercising care to prevent damage to the thin label, gently prise off PAN DRAG label (52)
(Fig 6.2) and remove the adhesive tape from drag knob (49).
48.4 Unscrew and remove three M4 countersunk head screw (50) and remove drag knob (49).
48.5 Unscrew and remove two M2.5 countersunk head screws (48) (Fig 6.3) securing drag knob
retainer (47) and remove retainer (47).
48.6 Remove drag knob centre (46)
48.7 Remove snap ring (83).
48.8 Withdraw side plate assembly (82) and remove bearing shield (66).
Dismantle and assemble
49 The dismantle and assembly procedures for the side plate assembly are self-explanatory using
standard techniques. Refer to Fig 6.4.
Refit
50 The side plate assembly is refitted as follows:
50.1 Reverse the procedure at Para 48.
To Next Page
Loading...
