13
Contents
Previous
Page
First
Page
Next
Page
Previous
View
8 The camera mounting plate (6) is a sliding fit in the head, adjustable fore and aft by 50mm from its
central position and is graduated along one edge to assist in repeat camera set up. A platform lock, operated
by a rotary lever (1), is located on the right-hand side of the head for adjustment of the plate position. The
head also has a release device (13) on the left-hand side, which allows removal of the camera and mounting
plate complete. To remove the mounting plate, release the slide clamp and move the mounting plate fully
rearwards. Operate the release by depressing it in the direction of its indicator arrow and holding. With the
release depressed, the end stops which limit the mounting plate travel are disengaged, and the plate can be
slid bodily from the head. This feature is an aid to rapid camera set-up.
9 Attachment points (3) for the pan bar are located at the rear of the head, on either side of the camera
mounting platform. The pan bar (9) is fitted using a pan bar clamp, with angular adjustment available on the
mount serrations. A second pan bar may be fitted. A level bubble (4) is fitted to the rear of the pan housing.
To Next Page
Loading...
