Accessories
Installation Method
Tips
Interface
Inserting / Removing the memory card
Formatting the card
LED
Buttons and Icons
Switch ON
Switch OFF / ON
Loop Recording
Emergency Recording
Motion Detection
Play
PC Mode
Mute
Firmware Upgrade
Table of Contents
Setting
Notice
Installation
3
6
11
2
Introduction
Operation
......................14
Customer Service ......................17
• Do not install or operate the camera with wet hands.
• Do not install the camera in a humid location or anywhere near
liquids and inflammable gases. The camera should be
installed/mounted in a location that does not compromise the
driver’s visibility and safety.
• Do not leave the camera installed/mounted inside an airtight
vehicle being exposed to extreme heat.
• Do not use the power that exceeds the rated voltage.
• Only use the original charging cable. The manufacturer is not
liable for damage resulting from the use of other charging cables.
• Do not disassemble the camera or its charging cable. Do not cut
the charging cable. Damage caused will not be covered under
warranty.
• Do not press the lens forcefully.
• Do not use any sharp objects on the camera or its accessories.
• Do not remove the Micro SD card when the camera is recording
or shutting down (avoids file damage).
• It is recommended to use a class 10 Micro SD card with a capacity
of 8GB or more (maximum supported capacity is 256G).
• To ensure stable read and write operations, it is necessary to
format the Micro SD card in-camera before initial use.
• Do not interrupt the power supply during a system upgrade, or
else the camera may not boot
• Product features/functions and content of this manual may
change without further notice.
Notice
To Next Page
Loading...
