VIOMI V3 Max - Machine Operation and Settings; 5. Start sweep by operating it from the app or pressing manually; System reset; Restoring Factory Settings

When the machine is not charging, press and hold both +
buons for 10 seconds. When you hear a voice saying "Factory
seings will be restored"，press and hold the buons again for 10
seconds until it says "Factory seings restored successfully"， the
seings are successfully restored，all user data will be cleared.
09
5.Start sweep by operating it from the app or pressing manually.
The machine automatically returns to the charging dock for
charging under the following conditions:
A. The machine has completed sweep;
B. Sweep has not been completed yet but the baery power level is
insufficient; Once the baery is charged to 80%, the machine will
resume to complete the remaining sweep work.
• If the machine does not respond aer pressing any buon thereon,
it is an option to reset the system.
1. Ensure that the machine is not on the charging dock;
2. Press the reset buon with a paper clip and the machine will shut
down automatically.
3. Connect the machine to the charging dock or press and hold the
key for 3 seconds to turn it ON and system reset will be complet-
ed.
Note:
• Do not move the charging dock during sweep, and make sure the
charging dock is powered on, or the machine may not be able to
return for charging.
• If automatic recharge fails, you shall manually connect it to the
charging dock.
• Do not place the charging dock in an area with direct sunlight.
• If the vacuum-mop is unable to turn on due to low baery, place it
directly onto the charging dock to recharge.
• The vacuum-mop will automatically turn on when it is on the
charging dock.
• The vacuum-mop cannot be turned off when it is on the charging
dock.
• Remove the water tank and mop holder when the vacuum-mop is
charging or not in use.
• Use the virtual wall or set restricted areas for carpeted areas to
prevent the vacuum-mop from geing caught on the carpet.
• Regularly clean the dust compartment to prevent excess dirt
accumulation. This can avoid reducing the cleaning performance of
the vacuum-mop.
Note:
• Aer reseing the system, the machine may lose maps and original
seings including the virtual boundary.
System reset
Restoring Factory Seings