1. Flip the vacuum-mop over and
pinch the clips to remove the main
brush guard.
2. Remove the main brush and the
main brush bearing.
3. Use the cleaning brush to clean
the main brush.
4. Reinstall the main brush and its
bearing, then put back and press
down the main brush guard until it
locks into place.
Note: It is recommended to replace the main brush every 6–12 months for optimal
cleaning effectiveness.
Filter
To clean the filter in the dust
compartment and 2-in-1 dust
compartment with water reservoir,
remove it as indicated in the diagram.
Main Brush
It is recommended to replace the side brush every 3–6 months for
optimal cleaning effectiveness.
• Aer rinsing the filter with water, make sure it is thoroughly dry when
reinstalling the filter into the dust compartment or 2-in-1 dust
compartment with water reservoir.
• To prevent the filter from becoming clogged, it is recommended to
regularly clean the filter using the cleaning brush.
• It is recommended to replace the filter every 3 to 6 months.
Periodically remove and clean the side brush.
Side Brush
Clean the cliff sensors every three months using a so cloth.
Cliff Sensors
Cliff Sensors
12
Clips
Main Brush Guard
Main Brush
Main Brush Bearing
To Next Page
Loading...
Need help?
General
