10
Section 7: Basic Operation
1. Insert one end of the DP cable into your PC’s graphics card. An HDMI cable may
also be used. An HDMI cable not included.
2. Connect the other end of the cable to the corresponding connector on your
monitor.
HDMI Connectors
DP Connector
3. Connect the power cable to your monitor then connect the other end to your
power source. It is recommended that you use a surge protector with adequate
voltage if a wall outlet cannot be reached directly.
4. Locate the power button on the monitor and press it to turn the monitor on.
FreeSync
The feature itself is on by default. In order to use this feature, please note you must
have hardware with FreeSync capability, a DP cable, and the latest graphic drivers.
To use this feature, connect your computer and monitor with a DP cable. After
connecting, you may receive a prompt to enable the feature on your computer. If
you do not receive the prompt, you may need to enable the function in your graphics
card menu. See your graphics card manufacturer’s documentation for instructions
on how to turn on and/or enable FreeSync.
Section 8: Indicator Light
Indicator Light
A solid blue light indicates power is on and the monitor is operating normally.
Flashing blue light indicates no video source has been detected. Red light indicates
that no horizontal or vertical signal has been detected or voltage is low. Please
ensure your computer is on and all video cables are fully inserted and/or connected.
To Next Page
Loading...
Need help?
General
