Viotek GNV29CB User Manual

7
Section 4: Stand Installation
Keep the foam underneath the monitor before attaching the stand.
1. Open the package and take out the monitor with foam still attached. Gently place
it on a desktop or table.
2. Take out the stem and base. Insert the stem into the base then use the included
screwdriver and one NO.1 screw to fasten base to the stem.
NO.1 Screw x 1
Stand Stem
Base
3. Remove the foam covering the back of the monitor, then insert the stem with base
into the adapter on the back of monitor. Use one NO. 1 screw to fasten stem onto
the adapter.
4. Take out the decorative cover and cover it in place on the stem.
Decorative Cover
NO.1 Screw x 1
5. With the stand fully assembled, reattach it onto the back of monitor. Then remove
the remaining foam on monitor and stand it up on a at, level desktop or table.
Make sure the monitor is laid on a at surface before removing the stand.

Viotek GNV29CB Specifications

General

Color	black
Screen Type	led
Wall Mount	75mm x 75mm
OS Compatibility	windows, linux, mac
Screen Size	29 inches
Panel Type	va
Aspect Ratio	21:9
Resolution	2560 x 1080
Refresh Rate	120hz
Horizontal Viewing Angle	178 degrees
Response Time	4 milliseconds
Brightness	280 candela per square meter
Contrast Ratio	3000:1
Synchronization	freesync (amd adaptive sync), g-sync compatible (nvidia adaptive sync)
HDR	no
Width with Stand	27.3 inches
Net Weight without Stand	9.2 pounds