7
Section 4: Stand Installation
Keep the foam underneath the monitor before attaching the stand.
1. Open the package, take out the product with foam still attached, and gently place
it on a desktop or table. Next, take out the stem, cable clip, and base, use the
included screwdriver and two screws to fasten base to the stem.
Screws x 2
Stand Stem
Cable Clip
Base
2. Remove the foam covering the bottom of the monitor, and remove the rubber post
attached on stem. Use a screw to fasten the stem onto the monitor, then reinstall
the rubber post on the stem.
Rubber Post
Screw x 1
Make sure the monitor is laid on a at surface before removing the stand.
To Next Page
Loading...
Need help?
General
