Front panel width 2.5 ... 6mm
Installation cutting (B x H) 311 x 249mm
Front panel (B x H) 325 x 263mm
Rear panel (B x H x T) 310 x 248 x 50mm
Installation depth 50mm
The degrees of protection are only guaranteed when the
following is observed:
– Material thickness at the mounting cut-out: 2.5 ... 6mm
– The deviation from the plane for the panel cut-out is
£
0.5mm.
– Permissible surface roughness in the area of the seal:
£
120µm (friction coefficient 120)
10" - 62K-NHC0-...
VIPA HMI Touch Panel Hardware description
Dimensions
HB160 | TP-ECO | 62K-NHC0 | GB | 14-27 17
To Next Page
Loading...
