30 © 2003 Directed Electronics, Inc. Vista, CA
transmitter configurations
The transmitters can be programmed with the separate or single button arm/disarm configurations by using the
Auto-learn functions in the Transmitter/Receiver Learn Routine.
controls the Lock/Panic ON/Panic OFF function.
controls the Disarm function.
controls Silent Mode™and an Auxiliary Output.
controls Remote Start.
/ controls Timer mode.
+ controls Turbo/Short Run.
+ controls Channel 4 output.
operating settings learn routine
The System Features Learn Routine™ dictates how the unit operates. Due to the number of features, the
features have been divided into two menus. It is possible to access and change any of the feature set-
tings using the Valet®/Program switch. However, this process can be greatly simplified by using the Bitwriter™.
Any of the settings can be changed and then assigned to one of up to four transmitters, a feature called Owner
Recognition. Each time that particular transmitter is used to disarm the system, the assigned feature settings will
be recalled. Owner Recognition is only possible when programming the unit via the Bitwriter.
The learn routine may be locked if previously programmed using the Bitwriter. If the horn generates one
long honk when attempting to program the unit, the learn routine is locked and must be unlocked using
the Bitwriter™ before proceeding.
button configuration
To Next Page
Loading...
