Viper 4806V - Fault Condition Alerts

7
© 2013 Directed. All rights reserved.
Remote Control Command table
Basic
Commands
Advanced Commands
Button
Level
Direct Access
x 1 x 2 x 3 x 4
Lock Silent Lock
Unlock Silent Unlock Remote Valet Car Finder
Remote Start Reset Runtime Timer Start Smart Start Defogger
AUX
Aux/Trunk AUX 1 AUX 2 AUX 3 AUX 4
Advance
Level, Change
Car (3 sec),
Enter program-
ming (8 sec)
Cabin Temp.
Request
(2- way only)
Lock
Status
(2- way
only)
Runtime
Check
(2- way only)
Fault Condition alerts
If, when performing a command, a condition exists that does not al-
low activation of the remote start feature* a fault tone plays to alert of
the fault condition.
* Remote Start feature not available when the Remote Start status is
incorrect upon receiving the command. (Example: Runtime reset com-
mand received when remote start is off)
Refer to the notes included in the command descriptions that address
these faults or go to Remote Start Faults under the Remote Start Fea-
tures section for more details.