Start cleaning by placing the hands on the
safety switches
Use and maintenance
Operating guidelines AS4325B
July 2020
Turn on the machine and verify there is
enough battery power to complete the
work. Charge batteries if required.
Lift the deck by pressing the pedal
Place the brush or the pad-holder under the
deck and Lower the deck or the brush/pad-
holder by pressing the pedal
With the machine on, press one of the safety switches to engage the brush/pad-holder, then
release it. If necessary, repeat the procedure until the brushes/pad-holder is engaged.
The squeegee is raised and lowered with the deck.
Check the solution level the red ball on the
left side of the machine.
Lift the squeegee up by hand until it locks in
up position and turn suction off for double
scrubbing. To go back to working mode,
use the red lever to release the squeegee.
and turn suction on again.
Press the + or – buttons to increase /
decrease the solution ow rate.
Remove the red cover, ll the tank with
clean water and use maximum temperature
40 degree. Add appropriate low foaming
detergent according to dosage information.
When scrubbing is complete, turn off
the machine to perform the following
maintenance
To Next Page
Need help?
General
