3
8. Adjust solution flow by adjusting the position
of ball valve knob.
WHILE OPERATING MACHINE
1. Occasionally look through the clear recovery
tank lid to see if there is any foam build-up. If
excessive foam is found, add defoamer to the
recovery tank.
: Foam must not enter the float shut-off
screen, or damage can occur to the vacuum motor.
Foam will not activate the machines float shut-off
device.
2. Occasionally view the clear tube at the back
right of the machine to check the amount of
cleaning solution that is right of the machine.
If the squeegee assembly leaves streaks on the
floor, raise the squeegee off the floor and wipe the
blades down with a damp cloth.
: Do not use your fingers to wipe or
re move debris from the blades, as injury may
occur.
When the solution tank runs empty, turn off the
brush switch and ball valve of solution tank.
Keep the squeegee down and continue to vacuum
until all the dirty water is picked up.
TANK DRAINING
1. Turn the switches on the control panel to
“off ” position.
2. Raise the squeegee, transport machine to
appro ved area for draining tank(s).
DRAINING THE RECOVE RY (DIRTY) TANK
: Any time scrubbing is completed, or when
refilling solution tank, the recovery tank should be
dra ined and cleaned.
: If the recovery tank is not drained
when the solution tank has been refilled, foam or
water may enter the float shut-o ff mechanism and
cause damage to the vacuum motor.
1. Remove the drain hose from t he holder, and
place the drain hose over the floor drain.
Twist off the drain hose plug to begin the
dra ining process.
2. Clean the recovery tank after every use. Use a
fresh water hose to rinse out the recovery tank.
Be careful not to spray water into the float
shut- off mechanism.
: If you are storing the machine for any
per iod of time, always leave the clear recovery
tank lid off the tank so the tank can dry
completely and smell fresh.
DRAINING THE SOLUTION (CLEAN) TANK
: Any time scrubbing operation is completed,
the solution tank should be drained and cleaned.
1. Pull down on the clear tube (back right of the
machine) to remove it from the hose barb.
This will al low the solution to flow freely into
a bucket or floor drain.
2. Rinse the solution tank with clean water after
every use. This will help prevent chemical
buildup and clogging of the solution lines.
3. Once tank is rinsed, flushed and drained,
reconnect the clear tube to the hose barb. Be
sure the tube is pushed all the way up on the
hose b
ar b.
PREVENTATIVE MAINTENANCE
: Before performing any maintenance on
the machine, be sure that the power is turned off.
: Repairs are to be completed by
Authorized Service Centers only. Any repairs
completed by unauthorized persons will void the
warranty.
1. Remove pad driver / brush and clean with
appro ved cleaner.
2. Drain recovery and solution t anks completely
and rinse out with clean water. Visually check
the recovery tank for debris and clean out as
necessary.
3. Raise squeegee asse mbly off floor and wipe
To Next Page
Loading...
Need help?
General
