BAS IC TROUBLESHOUTING
PROBLEM CAUSE SOLUTION
The wiring not connected correctly or
bad wir ing
Check the wiring or contact Viper Distributor
Bad brush motor Contact Viper Distributor
Carbon brushes worn out Contact Viper Distributor
The wiring not connected correctly or
bad wir ing
Check the wiring or contact Viper Distributor
Bad vacuum motor Contact Viper Distributor
Carbon brushes worn out Contact Viper Distributor
Bad ball valve Contact Viper Distributor
Bad solution valve Contact Viper
Distributor
Ball valve position in need of
adjustment
When ball valve is in horizontal position. The
amount of solution flow is maximum.
Squeegee clogged Clean debris off squeegee with damp towel
Squeegee blades worn Install new squeegee blades
Squeegee not mounted correctly
Confirm that the squeegee assembly is securely
fastened to the machine and not loose fitting
Vacuum hoses have a hole or are loose
Check hose connections and make sure they are
firm. Repla
ce hose if damaged.
Vacuum hose may be clogged Check hose for debris and remove any clog.
Drain hose stopper is loose Tighten drain plug.
Vacuum motor is loose
Tighten vac motor mounting screws. Do not
over tighten or damage will occur.
Recovery tank lid is loose
Confirm the clear recovery t ank lid is securely in
place.
Recovery tank is full Drain recovery tank
Float shut off is clogged
Remove float shut off from inside recovery tank
and remove any debris
No Power
Vacuum motor
doe
s not run
Little or no
solution flow
Poor water pick
up
5