17
Operation
Riding with Throttle Control
1. Insert the key (26) into its socket on the battery and turn it clockwise to “ON”. The LCD
display on the right handlebar should turn on, displaying the remaining power of the battery.
2. Turn the throttle handle on the right handlebar to activate the motorized wheel.
3. To speed up, turn the throttle handle further. To slow down, ease the throttle handle back
and/or press your brake levers. Pressing either brake lever completely will cut o all power
from your battery to the motorized wheel, temporarily leaving it in neutral. Release the brake
lever to restore power.
4. To stop your tricycle, release the throttle handle completely and apply your brakes as
needed. Press the emergency stop button below the LCD display if necessary, which will cut
o the power immediately even if the throttle handle is not released.
5. To turn off the motorized wheel, release the throttle and brake levers while the tricycle is
completely stopped. Turn the key counterclockwise to “OFF” and the LCD display will turn
o.
Riding with Pedal Assist Control
1. Insert the key (26) into its socket on the battery and turn it clockwise to “ON”. The LCD
display on the right handlebar should turn on, displaying the remaining power of the battery.
2. Make sure the throttle handle is fully released.
3. Turn the pedals on your tricycle once. The pedal assist system (PAS) will activate and turn
the wheels using the motor’s power immediately, allowing the tricycle to reach its highest
speed.
4. Turn o the pedal assist system by turning the throttle handle or pressing the brake lever.
The tricycle will default to throttle control or neutral. Press the emergency stop button below
the LCD display if necessary, which will cut o the power immediately, defaulting the tricycle
to neutral.
Ride with Manual Control
To ride your tricycle normally, leave the key (26) at “OFF” on the battery or remove the battery.
To Next Page
Loading...