Need help?Do you have a question about the ViscoTec Preeflow eco-CONTROL EC200-K and is the answer not in the manual?
Manual must be kept at site, supplemented by local rules for accident prevention and environmental protection.
Remove/insert mains plug only when power is off to prevent motor electronics damage.
Follow instructions to prevent damage/injury; high pressures, air bubbles, chemical hazards.
Step-by-step instructions for safe startup, including connecting dispenser and power supply.
Instructions for calibrating the controller/dispenser for accurate dispensing, including auto and manual methods.
Step-by-step guide for automatic calibration to set flow rate and save parameters.
Enabling and setting a password to block access to controller settings and function keys.
Procedure to unlock the controller using the correct password when protection is active.
Steps to deactivate the password protection feature on the dosing system.
Managing system and error message alerts, including switching them on/off.
Initiating the dosing process using selected programs (Quantity, Time, Start/stop) and viewing associated displays.
Procedure for bleeding the dispenser after filling, refilling, or cleaning to prevent damage.
Common errors like no display or program save failures, and their possible causes and corrections.
Specific error messages like 'Overcurrent monitoring' and their troubleshooting steps.
General| Control Type | Electronic |
|---|---|
| Power Supply | 24 VDC |
| Dispensing Accuracy | ± 1 % |
| Protection Class | IP40 |
| Dispensing Volume | ≥ 0.001 ml |
| Material | Stainless steel |
| Control Interface | RS-232 |
| Housing Material | Aluminum |
| Operating Temperature Range | 5°C to 40°C |
| Fluid Viscosity | 1 to 2, 000, 000 mPa·s |
To Next Page
