What to do if ViscoTec preeflow eco-PEN330 Dispenser material is dripping?
If your ViscoTec Dispenser is experiencing dripping or running of material, consider the following: * The suck-back might not be set correctly, so adjust it. * There may be air bubbles in the material. Bleed the dispenser and material pipes to remove them. * The material may be compressible; in this case, degas the material.
How to fix ViscoTec preeflow eco-PEN330 with no material feeding?
If your ViscoTec Dispenser isn't feeding material, it could be due to a number of factors. Start by checking if the motor is connected properly. Then, inspect the electrical supply for any faults. If the material has hardened, you'll need to dismantle and clean the dispenser. Also, check the dosing needle for blockages and clean or replace it. If the needle is the wrong size, use a different one and reduce the flow rate. Other potential issues include worn stator/rotor (replace if necessary), a swollen stator (check resistance and replace), incorrect revolution (correct it), or an inadequate material supply (feed material and check inlet pressure).
Why is my ViscoTec preeflow eco-PEN330 not feeding material properly?
There could be several reasons why your ViscoTec Dispenser isn't feeding material correctly. Here are a few things to check: * Make sure the motor is properly connected. * Check your electrical installation to ensure there are no issues with the mains supply. * If the material has hardened or set, dismantle and clean the dispenser. * Inspect the dosing needle for blockages and clean or replace it if necessary. * Ensure the dosing needle isn't too small or too long; if it is, use a different needle cross-section and reduce the speed/flow rate volume. * Check the stator and rotor for wear and replace them if needed. * If the stator is swollen, check its resistance to the material and replace it if necessary. * Correct the revolution if it is too low. * Also, ensure there's...
Lists the items included in the product's delivery scope.
Instructions for checking the delivery for transit damage and completeness.
Explains the meaning of symbols and safety notices used in the manual.
Defines the proper application of the eco-PEN330 dispenser and lists misuse cases.
Outlines qualifications, training, and responsibilities for operators and maintenance staff.
Lists essential documents to be read, understood, and followed for safety.
Provides critical notes to avoid damaging the dispenser and ensure dosing precision.
Covers the provision and use of personal protective equipment (PPE).
Identifies potential hazards like material toxicity, moving parts, and pressurized material.
Specifies ambient conditions for safe transportation and storage of the dispenser.
Steps for setting up the dispenser, including fitting the stator and calibration.
Daily procedures for starting the dispenser and initiating the dosing process.
Steps for safely shutting down the dispenser and ending the dosing process.
Instructions for safely taking the dispenser out of service.
Details on how to put the dispenser back into operation after decommissioning.
Recommended schedule for visual checks and periodic disassembly for cleaning.
A guide to identifying and resolving common faults and their causes.
Procedures for preparing, disconnecting, and removing the stator.
Steps for disassembling the dispenser for cleaning purposes.
A comprehensive list of all available spare parts with their identifiers.
Visual representation of spare parts and their locations within the dispenser.
Legal declaration regarding compliance with EU machinery directives.
Detailed technical specifications, operating parameters, and threads used.
Lists the materials used for components in contact with the media.
Provides detailed physical dimensions and mounting bore information.
General| Type | Piston Dispenser |
|---|---|
| Dosage Accuracy | ± 1% |
| Repeat Accuracy | ± 0.5% |
| Power Supply | 24 V DC |
| Materials | Stainless steel, ceramics |
| Interface | Ethernet, RS232 |
To Next Page
