Viscount CANTICUS I - II
52
Remember that when a saving procedure is carried out, the data relating to all the memories are saved onto the floppy disk.
The appearance of "dEr" (disk error) or "Ejt" (Eject) informs the user that the disk has not been formatted (see formatting
procedure in point 4.4), while the "dPr" (disk protected) error indicates that the disk inserted is protected against data
writing. In both cases, repeat all the saving procedures.
6.4 LOADING MEMORY CONTENTS FROM DISK
To reload the memory content data into the instrument, insert the appropriate disk and press the SETTING key. Then press
the PAGE
×
key until the display shows:
$0-+ C
1#*#!2 -, "'1) ," .31& R
With the aid of the SONG
Õ
and
Ö
keys, select the number of the file containing the memory data to be loaded into the
instrument on the 3 digit display.
Use the CURSOR
Ö
key to confirm the selection made. The alphanumeric display will show:
$0-+ C 30# T
.31& R 2- !-,$'0+ -0 2- -02
Press EXIT to abort the operation or the CURSOR
Ö
key to start the procedure for loading the memory data. The drive
LED will illuminate and for few moments the display will show:
$0-+
1202#"C 5'2',% #," -$ "'1)
When the procedure is complete the instrument returns to the main video page.
N.B.: Save the memories
on disk
BEFORE
loading from disk, since the new configuration will replace the existing one.
"dEr" (disk error) or "Ejt" (eject) on the 3 digit display indicates that the disk is illegible; insert the appropriate disk and
repeat the operations. The "noS" message on the 3 digit display indicates that the disk does not contain any information.
SONG Key
3 Digit Display
To Next Page
Loading...
Need help?
General
