Owner's Manual – Viscount CantorumVI
1.1 LOOKING AFTER THE PRODUCT
• Do not apply excessive force to the product’s structures or the controls (knobs, connectors,
push-buttons, etc.).
• When possible, do not place the instrument close to units which generate strong
interference, such as radios, TVs, computer videos, etc.
• Do not place the product close to heat sources, in damp or dusty places or in the vicinity of
strong magnetic fields.
• Do not expose the product to direct sunlight.
• Never insert foreign bodies inside the product or pour liquids of any kind into it.
• For cleaning, use only a soft brush or compressed air; never use detergents, solvents or
alcohol.
• Always use good quality screened cables for connection to amplification or diffusion
systems. When disconnecting cables from sockets, always take hold of the connector and
not the cable itself; when winding cables, do not knot or twist them.
• Before making the connections ensure that the other units (especially amplification and
diffusion systems) you are about to connect are switched off. This will prevent noisy or even
dangerous signal peaks.
• Connect the net cable to an earthed socket.
• Check that the voltage corresponds to the voltage shown on the serial number plate of the
product.
• If the product is to be out of use for lengthy periods, disconnect the plug from the power
socket.
1.2 NOTES ABOUT THE MANUAL
• Take good care of this manual.
• This manual is an integral part of the product. The descriptions and illustrations in this
publication are not binding.
EN - 2
To Next Page
Loading...
