Vishay ESTAmat PFC - Setting Menu - Modifying the Parameter; Setting Menu - Completing and Memorizing the Parameter; Setting Menu - Description of the Parameter

Issue February 2002
Document Number: 13124
- 20 -
The set value is stored via the key
Thereafter, the parameter is displayed in alternation with the modified value.
6.2.3. Setting menu – Completing and memorizing the parameter
By means of the keys or the parameter's number
is to be modified until the display indicates
DONE
. This display will appear at the moment when the
number of the parameter changes from -1- to -19- or from -19- to -1- .
Thereafter, the key is to be pressed. The display
SAFE
flashes.
By means of the keys or the display can now be
commutated between
SAFE
,
RST
and
[AN
The display continues flashing.
SAFE
= The modified parameter values will be stored.
RST
= All parameters will be returned to their RESET values.
[AN
= The menu is exited. Any modification will not be stored.
By pressing the key the selection will be confirmed. Thereafter, the Controller
runs a new start-up of the program or, in case no significant parameters have been modified, it returns
to the calling menu position.
A new start-up of the program without modification of the parameter will also be carried out if, after
activating the setting menu, no key operation takes place for a period of 2 minutes.
6.3. Setting menu – Description of the parameter
In the setting menu, 19 parameters can be modified.
Number Implication
- 1-
Modes of initialization AU1, AU2 or AU3
- 2-
Type of measuring voltage L-N or L-L, only to be set in case of AU1
- 3-
Connection of measuring voltage, to be set in case of AU2 and AU3
- 4-
Switching program, to be set in case of AU3
- 5-
C/k value, to be set in case of AU3