CALIBRATION GUIDES
1
Date of last revision: 9.06
BIKE.CALIB.RB111.CB125.REV1
STEP 1 ENTER ENGINEERING MODE
•Press and hold the “UP ARROW” and the “DOWN
ARROW”
buttons simultaneously for five seconds.
•You will hear a series of beeps and the display will read
““UUSSEERR SSEETT””
.
STEP 2 SELECTING ENGINEERING MODE
•Press the “UP ARROW” or “DOWN ARROW” buttons
to view the various Engineering Modes.
•Press
“ENTER” to select the desired mode.
STEP 3 USER SET MODE
•Setting Default Time
- The top left window will be flashing the default time.
-Use the
“UP ARROW” or “DOWN ARROW”
buttons to set default time.
- Press and hold
“ENTER” for approximately three
seconds to save the default time.
- Press
“ENTER” to go to Default Level.
•Setting Default Level
- The bottom right window will be flashing the default
level. Use the
“UP ARROW” or “DOWN ARROW”
buttons to set default level.
- Press and hold
“ENTER” for approximately three
seconds to save the default level.
•Accumulated Time
- The center left feedback window will display
accumulated hours of use.
•Accumulated Distance
- The center right feedback window will display
accumulated distance in miles or kilometers.
•To EXIT USER SET MODE press and hold
“START” for
approximately three seconds.
Calibration Guide
100 Series
Model: R2150 (RB111), E3100 (CB125)
AND CONSULT YOUR PHYSICIAN BEFORE CONTINUING.
1. Choose PROGRAM using arrows, press ENTER
2. Choose TIME using arrows, press ENTER
3. Choose WEIGHT using arrows, press ENTER
4. Choose LEVEL using arrows, press ENTER
5. Press START to begin