13
E4000
BATTERY REPLACEMENT
1. Refer to the illustration below to remove battery cover.
2. Replace 2pcs. of 1.5V AA batteries.
3. Make sure batteries are installed correctly and connected with the
battery springs.
4. If the display is illegible or partial segments appeared, please take out
the batteries. Wait 15 seconds and then re-install.
5. Battery life is approximately two months under normal usage.
6. When removing the batteries, all functional values will be reset to zero.
CHANGING RESISTANCE
There are two ways to increase
your workload. You can pedal
faster, or you can turn the tension
knob which is located below the
console. The tension knob will
adjust to one of 15 levels of
resistance.
To Next Page
Loading...
Need help?
General
