7
Fuel Pressure Alert:
The system has a built-in warning system and will flash should fuel pressure move
outside of the limits for your particular engine.
Fuel Flow:
Fuel Flow is displayed both digitally and graphically. As fuel flow increases, the graph
increases proportionately. The digital display provides tenth gallon resolution.
There are four additional features that the fuel computer provides:
'REM' - Fuel remaining onboard
'BRN' - Fuel burned since last power-up
'HRS' - Hours of fuel remaining
'ADD' - Add fuel to computer memory.
An exclusive feature of our fuel flow computer is its ability to 'damp out' the wide
variations in displayed fuel flow normally seen on other fuel flow digital readouts. Our
system will smooth these short term flow variations to give you a steady flow indication
with NO sacrifice in accuracy.
Fuel Remaining Alert:
Your fuel computer has a built-in 'Low Fuel Remaining' warning annunciator. When the
computed fuel total is less than a factory programmed amount (10 gallons standard), the
display will flash.
1.5 ADDING FUEL TO THE FUEL COMPUTER
***************************** WARNING *********************************
IMPROPER USE OF THIS FEATURE WILL GIVE YOU INCORRECT FUEL 'REM' AND
‘HRS’ INFORMATION. INSURE THAT YOU UNDERSTAND THE OPERATION OF
THIS SYSTEM BEFORE USING IT INFLIGHT. AFTER INSTALLATION AND
PERIODICALLY THEREAFTER, VERIFY THAT THE SYSTEMS ACCURACY IS
ACCEPTABLE FOR YOUR INTENDED USE.
****************************************************************************
Your fuel computer has a unique feature that allows you to 'ADD' fuel according to how
much has been pumped into the tank(s). You are not required to calculate the new total
fuel level after adding fuel, as on many other fuel computers. This system does it for you.
Follow the steps below to 'ADD' fuel to the computer, referring to 'Error! Reference
source not found.’:
STEP 1. Press 'BUTTON 4' until the 'ADD' indicator activates
STEP 1. Press 'BUTTON 3 to add tens and 'BUTTON 5' to add ones to match the fuel
that was pumped into the tank(s).
NOTE: To 'top off' the tank(s) just press 'BUTTON 3' to run up a number more
that your max capacity. The system will only add what is needed to 'fill' the
computers electronic tank to its max capacity as set up in 'Error! Reference
source not found.'.
To Next Page
Loading...
Need help?
General
