Vision 5 Series Installation Guide

Machine Setup 19
© 2020 Vision Engraving & Routing Systems
Additionally, the Misting System Power Plug on the machine connects to the controller's Pump/Mist port
with the supplied cable.
2.6 Network Connection
NOTE - This following section is shown on a Windows 10 PC. For Windows 7 or Windows 8, the screens
are slightly different.
Plug the USB end of the USB to Ethernet adapter into any open USB port on the computer.

Vision 5 Series Specifications

General

Brand	Vision
Model	5 Series
Category	Engraver
Language	English