Vision 5 Series Installation Guide

All rights reserved. No parts of this work may be reproduced in any form or by any means - graphic, electronic, or
mechanical, including photocopying, recording, taping, or information storage and retrieval systems - without the
written permission of the publisher.
Products that are referred to in this document may be either trademarks and/or registered trademarks of the
respective owners. The publisher and the author make no claim to these trademarks.
While every precaution has been taken in the preparation of this document, the publisher and the author assume no
responsibility for errors or omissions, or for damages resulting from the use of information contained in this
document or from the use of programs and source code that may accompany it. In no event shall the publisher and
the author be liable for any loss of profit or any other commercial damage caused or alleged to have been caused
directly or indirectly by this document.
Revised: 5/14/2020
Vision 1612, 1624, 2424 and 2448 Series 5 Installation Guide
© 2020 Vision Engraving & Routing Systems

Vision 5 Series Specifications

General

Brand	Vision
Model	5 Series
Category	Engraver
Language	English