Vision AV-1000 - User Manual

Questions and Answers

J
jeffreycoxAug 15, 2025
What to do if Vision AV-1000 Speakers power light is on but there's no sound?
- T
  Tonya EricksonAug 15, 2025
  If the Vision Speakers' power light is on, but no sound is produced, the battery in the remote control may be flat. Try turning the volume dial on the back panel of the master loudspeaker up. Alternatively, a cable problem may exist. Bypass the installed input cables and plug an input device (like a laptop via the headphone jack) directly into the master speaker. Ensure the output volume on your test device is at full and that it works through the laptop speakers before plugging it in.
J
Jennifer WardAug 18, 2025
How to stop hum or noise from Vision Speakers?
- M
  Molly HernandezAug 18, 2025
  Humming or noise from Vision loudspeakers can be due to a poor-quality cable with uneven shielding, which introduces noise. Check that all input cables are shielded properly.
A
Anthony LopezAug 21, 2025
Why is the passive Vision loudspeaker quieter than the master loudspeaker?
- K
  Kristen McintoshAug 22, 2025
  If a passive Vision loudspeaker is quieter than the master loudspeaker, it's typically caused by the use of an incorrect cable between the master and passive loudspeakers. Replace the cable immediately.
B
Bryan MeyersAug 25, 2025
How to fix Vision AV-1000 when the power light does not turn on?
- P
  Pamela HuffAug 26, 2025
  If the power light on your Vision Speakers does not turn on, check the power source and the power input cable.
L
llinAug 28, 2025
What to do if passive Vision loudspeaker does not work?
- C
  Courtney RussellAug 28, 2025
  If a passive Vision loudspeaker isn't working, check the speaker cable to ensure there's a proper connection at both ends.
D
dustinmercadoAug 31, 2025
Why do my Vision Speakers have hum or noise?
- P
  Phillip PayneAug 31, 2025
  If your Vision speakers are producing hum or noise, the issue might be with the input cables. Ensure that all input cables are properly shielded, as poor quality cables with uneven shielding can introduce noise.
P
Phillip SmithSep 4, 2025
What to do if Vision Speakers power light is on but there is no sound?
- J
  Jill Watts DDSSep 4, 2025
  If your Vision speakers' power light is on, but no sound is coming out, the remote control battery might be flat. Try turning the volume dial on the back panel of the master loudspeaker up to test this. Alternatively, there may be a cable problem. Bypass the installed input cables and plug an input device, such as a laptop via the headphone jack, directly into the master speaker. Ensure the output volume on your test device is at full and working through the laptop speakers before plugging it in.
C
Cody SchultzSep 7, 2025
How to fix Vision Speakers if the power light does not turn on?
- E
  eandersonSep 7, 2025
  If the power light on your Vision speakers does not turn on, check the power source and the power input cable to ensure they are properly connected and functioning.
D
deborahhendricksSep 10, 2025
What to do if the passive Vision loudspeaker does not work?
- F
  fbooneSep 12, 2025
  If the passive loudspeaker of your Vision speaker system isn't working, inspect the speaker cable. Ensure there's a secure connection at both ends.